Oct 16 2009

Stitch Example: Single Bias Binding

Published by at 9:00 am under Sewing,Stitch Example

Continue reading to see how to do this.

Single Bias Binding - Part 1

Start by pressing the bias strip in half.

Single Bias Binding - Part 2

Open up the bias strip and press the edges into the center.

Single Bias Binding - Part 3

Then fold along the center crease and press again, making sure one side is slightly offset from the other.

Single Bias Binding - Part 4

Open up the bias binding and pin the shorter side to the right side of the fabric lining up raw edges.

Single Bias Binding - Part 5

Stitch in the fold.

Single Bias Binding - Part 6

Wrap the bias binding over the seam allowance and to the back. Press.

Single Bias Binding - Part 7

Pin the binding in place.

Single Bias Binding - Part 8

Here I top stitched to catch the binding in the back.

Single Bias Binding - Part 9

For the curved part, you can press the bias strip into a curve to make it easier to pin.

Single Bias Binding - Part 1

Repeat the same procedure as for the straight part.

Single Bias Binding - Part 1

On the curved part, I topstitched. On the straight part, I stitched in the ditch. You could also hand slip stitch it on the back.

No responses yet

Trackback URI | Comments RSS

Leave a Reply